L50 - How To

Our L50 scrubbing robot has a lot to offer, and can seem intimidating at first. This guide will show you how to create a task, and how to set up a schedule.

From the homepage, confirm the map and select the plus sign in the top right.

This will allow you to;

Set a time limit for the task, as to not spend too much time in one area.
Set an intensity level for the clean.
Set an amount of times you want the robot to cover the area.
Check the correct map is set for the task.
Decide if you want to clean the entire area, or only select parts.

Once happy with your selections, press Start in the lower right.

See the video below for more information.

To create a schedule, select Schedule on the left hand side. This page will show you the current Schedules set up within the robot. To create a new one, press +New in the top right corner.

Here, you can;

Set a start time for the task.
Set a time limit, the robot will not action the task longer than this.
Decide on what days you wish this task to be repeated.
Set the intensity of the clean.
Set how many times you wish the robot the cover the area before finishing.
Check the map is correct.
Decide if you want the robot to clean an area in particular, or the entire area.

When you are finished, press Save in the lower right corner. As long as the robot is switched on, and located inside the set map.

See the video below for more information.

When charging L50, please ensure that if doing so overnight, or for long periods of time where you will be away from the robot, ensure that the main break switch is set to OFF. This switch is red, and positioned at the lower back of the robot.