How to change the side brush of the SP50

Maintaining maximum performance of your SP50

The side brush must be checked daily. 

If it's time to replace the side brush please follow the following steps. 

First, please power off the robot. 

If you take a look/feel under the side brushed you will feel a screw, please use one hand to hold the brush and one hand to loosen the screw. 

Once the screw is removed you will be able to slide the brushes down of the robot. 

Once the brush is removed you will notice a small metal piece inside the old brush, please remove it and place it snugly inside the body of the new brush. Once it's in place just slide the brush back in place and tighten the screw. (this part is a bit fiddly) 

Once in place, the brush should feel snug, like so.